![]() Thank you! Yeah I've contacted ACL with my problem as well and they told me about this upcoming solution. ![]() There's no way to get smaller genes / grains that fire much less frequently is there? If I turn the gene size up to make smaller genes / grains, then they fire a lot faster. My other question is, is it possible to get tiny genes out of Morphagene without speeding up the rate that they play? Why does it not stop when the gate goes low when Morph is turned up? It seems that it will play the current splice as long as the gate on the play input stays high and then stop when I release my finger, unless I turn Morph up, and then when it triggers a second overlapping grain that will continue, even if I release my finger. I'm just triggering it with tapping a tetrapad at the moment with my finger sending it a gate out as long as my finger is held down. trying to learn it a little better, and I'm experimenting with triggers into the play input. I'm actually playing with my Morphagene at the moment. I don't think so, I have a feeling Arbhar might do this, but Arbhar offers far less trigger control than Morph, (there's quite a bit latency when triggering with Arbhar) I love the overlap where a gene starts before another has finished, but would love a bit more control over the timing of them. It ramps up to 12V very slowly.Ĭan someone give me a sanity check just to make sure I'm not missing something obvious?Īm I correct in understanding that using a trigger input to play, there's no way to get the gene play overlap that happens without a play trigger input when the morph knob is past 12 o'clock? The ACL Power Delay only gives the module the current when the 12V is reached. ![]() Good digital modules reset themselves until the 12V is reached. Because of the many modules in your case, the current needs a little time to reach 12V. Have any of you had similar experiences? Any solution to this problem other than selling it, which I really want to avoid? Make Noise say it might be a compatibility issue with the PSU (ACL Lo Noize) which possibly doesn't ramp up to 12V fast enough. It just won't behave normally in my new case as it invariably locks up during start-up, displaying purple lights all over and not reacting to any knob movements or inputs. I've recently encountered a new problem with the Morphagene.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |